How deep should ThermoPEX be buried?

Before digging, be sure to call for utility locator service. The trench depth for ThermoPEX should be between 10″ and 28″ (25 and 71 cm).

How deep does PEX have to be buried?

PEX pipes and all underground piping should be buried at least 12” to 18” below the frost line to protect the pipes from freezing. The frost line refers to the furthest depth underground groundwater begins to freeze, also called the frost depth. In colder zones, the frost line can be three to four feet down.

What temp should my outdoor boiler be set at?

between 170 and 185 degrees F.
A few notes on how most outdoor wood boilers operate: The boiler cycles on and off to maintain boiler water temperature between 170 and 185 degrees F.

How is a thermostat connected to the boiler?

Traditionally, the thermostat is connected to the boiler by wires running through the walls of the home. It is often located somewhere neutral, like the hallway, but it can often be in the main living room of the house, where occupants spend most of their time.

Can PEX pipe be buried in dirt?

Nowadays, PEX tubing is quickly replacing traditional copper and galvanized steel pipes and is an exceptional option for underground piping. PEX tubing is approved for direct burial outdoors.

How many cords of wood do you need for a wood boiler?

“The standard rule of thumb is that a 1,000-square-foot home will use three cords of wood for a season,” she says. “If your wood burning stove is super high-efficiency, or if you live in a more moderate climate, you may need less.”

Where can I get a central boiler installation and service guide?

Central Boiler Installation and Initial Water Treatment Guide SAVE THESE INSTRUCTIONS (p/n 9000800 – REV. B) For parts and accessories, service or repairs, call your authorized Central Boiler dealer or heating contractor. Record the information below for future reference.

What is the central boiler outdoor furnace installation guide 37?

Central Boiler Outdoor Furnace Installation Guide37 Pool and/or Hot Tub Heating Valves should be installed so the heat exchanger can be isolated and bypassed when shock-treating or adding chemicals to a pool or hot tub.

What is the model number for a classic Fuel Model boiler?

THE CLASSIC DUEL FUEL MODELS OWNER’S MANUAL (CL 4030, CL 5036, CL 6048, CL7260 manufactured on or after May 15, 2015) OWNER’S MANUAL (for Two Door Classic woodburning boilers manufactured after May 15, 2015)

Where can I find parts for a classic cl-5648 furnace?

Parts for a Classic CL-5648 (which will include parts assembly diagrams, if available) can be found by entering your serial number below. Troubleshooting information, technical articles and more information specifically for this furnace will also be available when you enter a serial number.