Are toilet bowls standard size?

Standard toilet dimensions are typically between 28–30″ deep, roughly 20″ wide, between 27–32″ high, and have a rough-in between 10–14″. Now you can find the perfect toilet.

Do toilets come in different widths?

Are there different sizes of toilet? Yes, toilets come in a range of different sizes, that’s why it’s important to measure your existing toilet seat before you buy.

What is the assembled width of a toilet?

The general rule of thumb for standard toilet sizing is between 27 and 30 inches deep, the back height is usually between 21 to 31 inches and the width is about 20 inches.

Can you replace a 10-inch rough-in toilet with a 12-inch rough-in toilet?

Ideally, the toilet’s rough-in should match the rough-in for your bathroom plumbing. However, even if a toilet is designed for a 10-inch rough-in, you can still install it into a space that has a 12-inch rough-in.

How do you measure a 10-inch or 12-inch rough-in for a toilet?

If the old toilet is still there, measure from the center of the capped bolts (on the bottom) to the wall (not the baseboard). There should be 24 inches of clearance from the wall facing the bowl and 15 inches on each side as a guideline. If your measurements are between 11.5 and 12.5 inches, it is a 12-inch rough-in.

Can you replace a 10 inch rough-in toilet with a 12 inch rough-in toilet?

How far do toilets stick out from the wall?

The Distance To Set The Toilet Flange From The Back Wall. You’ll want to set the center of the water closet flange 12 inches from the finished back wall.

How do I make sure my new toilet will fit?

If the base of the new toilet is shorter than the distance between the rear bolt holes and the wall, it should fit. In small bathrooms where space is tight, also measure from the sides of the flange bolts to the sidewalls or other objects to assure side-to-side clearance.

How much space is needed on either side of a toilet?

15 inches
Toilets and Bidets Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.)

What is the rough-in size for a toilet?

12 inches
Standard Toilet Rough-In Sizes The standard toilet rough-in is 12 inches, but don’t assume you have a 12” rough-in without measuring! Some older homes come with 10” or 14” rough-in sizes. You may also find 10” rough-in sizes in powder rooms, half baths, or other small bathrooms to save space.

How far should a toilet be from a side wall?

Toilets and Bidets Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture.

Can you replace a 10 inch rough in toilet with a 12-inch?

What are the rough in dimensions for a toilet?

Toilet Rough In Dimensions: A toilet’s rough-in measurement is the space between the wall behind the toilet and the center of the waste pipe. Standard toilet rough in dimensions are 12 inches but can be anywhere from 10 to 14 inches in some cases.