Should EQ come before compression?

Each position, EQ pre (before) or EQ post (after) compression produces a distinctly different sound, a different tonal quality, and coloration. As a rule, using EQ in front of your compressor produces a warmer, rounder tone, while using EQ after your compressor produces a cleaner, clearer sound.

Should EQ go before or after overdrive?

EQ or equalizer is recommended in front of distortion or gain based effects if you want to drive and color the sound. EQ after distortion will give you volume changes which allow you to switch to a louder lead sound which you cannot do if the EQ is before distortion.

Should I EQ before or after amp?

Before the amp is more like EQ’ing the guitar sound whereas after the amp will be shaping the overall sound. The difference is that an amp will respond differently according to what’s hitting the input. Before the amp will change the overall sound to a degree, but it’s more about changing the feel and response.

Do you compress after EQ?

An acceptable way to apply EQ pre and post compression would be to employ a single High-Pass EQ band pre compression, to sculpt your signal at a macro level before compression, and a multi-band parametric EQ post compression to really fine-tune the sound.

Who uses a phaser pedal?

The effect was first popularized by guitarists like Jimi Hendrix, Brian May, and Eddie Van Halen. By the ’70s, phasers were gaining traction amongst other instrumentalists like Bill Evans and Billy Joel. The popularity of this effect will also explain why there are a ton of phaser pedals on the market.

Where should EQ pedal go in pedal chain?

Where should I put my EQ pedal?

Placement is key with an EQ pedal, and you can use it a number of different ways. If you place the EQ pedal in front of your amp, it will have more of an effect on the response of your amp (same as turning the volume down on your guitar knob, or using a different boost pedal).

Should I do compression or EQ first?

What overdrive did Eddie Van Halen use?

MXR EVH 5150 Overdrive
MXR EVH 5150 Overdrive Pedal.

Is the MXR M108 a good EQ pedal?

The MXR M108 is a powerful 10-band EQ pedal that can dramatically change the way your signal works. But with so much control in one little box, it can be overwhelming, especially if you’re a new player and are unaccustomed to EQ parameters.

What do you think about the MXR 108s?

Enter the MXR 108S. This thing is quite a great tool. Small footprint, attached it with velcro to the board, quiet as can be an damn useable. I can see where more than one would be very usefeul for different tonal presets…and the dual outputs is a great feature for feeding either two amps or a direct out to a mixer for a clean sound.

How do I use the ten band EQ pedal?

The Ten Band EQ is very easy to use, as the sliders are a graphic representation of the pedal’s frequency response. Here are a few settings to help you get on your way, but the best way to use this pedal is to keep experimenting and tweaking until you find your own unique sound.

What’s the difference between the M108 and M108s?

The new one (M108S) is brighter and clearer than the old versions. It sounds very modern. The vintage blue 10 band, if you find one in good shape, is not particularly noisy, despite arguments to the contrary.